Welcome to DU! The truly grassroots left-of-center political community where regular people, not algorithms, drive the discussions and set the standards. Join the community: Create a free account Support DU (and get rid of ads!): Become a Star Member Latest Breaking News Editorials & Other Articles General Discussion The DU Lounge All Forums Issue Forums Culture Forums Alliance Forums Region Forums Support Forums Help & Search

Wash. state Desk Jet

(3,426 posts)
5. Well, I assume there is a light switch, inside I suppose.
Fri Jan 23, 2015, 05:20 PM
Jan 2015

At the switch is where the power is sent to the light. Am I correct in assuming that ? What I'm getting at is if I were to push the wire into the hole and seal off the holes, I would cut off the power source to the light either at the switch or the junction box which is behind the wall.

I suppose I would wonder about what all is on the circuit and so I would imagine the way to find that out is turn off the breaker that supplies that light and all else it supplies. That would give me a better idea about how the wiring is run inside the walls ,coming up or down the walls routed to the location -,i.e.. lights and plugs. Sometimes the box where the switches are located is also a junction meaning your power supply runs direct to the switch box than directed on to the source supply which is the light. If thats the case, than at the switch box -where the switch is ,the neutral -white wires are joined and tied with a wire nut. Than of course the black wire,power to switch ,the other black wire ,power feed to the location -light or plug, and your grounds which are joined and tied by a wire nut.

As it appears your question has an easy answer but, I don't know how much you know about residential wiring.What I can tell you is in the trades there is this saying goes with keeping the job on track-do it right or don't do it at all. A good electrical tester is a handy tool to have. And knowing how to use it is even more handy.

OK so, you terminate by cutting off the power supply to that location which is in effect decommissioning that feed line to the light. Than you push the wires into the hole and seal it off. To start your investigation into the mysteries of electrical wiring in this case you might remove the face plate at the switch ,remove the two screws the attach the switch to the switch box ,pull the switch out and look at the wiring .Of course shut of the power to that circuit at the breaker box. I mean there is like two ways it can go- the power is run direct to location at the light than routed down to the switch ,or it comes up to the switch and is routed from the switch to location.

If the power comes from source to switch than routed to the light -the neutrals tied together at the switch box -then for you it's an easy fix.

But thats wiring, sealing up the holes is simple-,just buy a small container of stucco patch at home depot !

Recommendations

0 members have recommended this reply (displayed in chronological order):

How do I terminate this? [View all] SHRED Jan 2015 OP
Call an electrician? valerief Jan 2015 #1
What you should do... OffWithTheirHeads Jan 2015 #2
Pull it bach through the wall. amerikat Jan 2015 #3
What I would do: ret5hd Jan 2015 #4
Well, I assume there is a light switch, inside I suppose. Wash. state Desk Jet Jan 2015 #5
Thanks all SHRED Jan 2015 #6
code violation. amerikat Jan 2015 #7
Thanks for that. SHRED Jan 2015 #8
Latest Discussions»Culture Forums»DIY & Home Improvement»How do I terminate this?»Reply #5